Hyperther Plasma Nozzle 220354 Cutter Accessories For HPR260XD / HPR260 Machine
 
Shanghai ZhouBo Welding & Cutting Technology is a professional manufacturer plasma consumables electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.
1.  HT4400, HT4001, HPR400XD, HPR260XD, HPR130XD, HPR260, HPR130, HSD130, HD3070, HD4070, HT2000, MAX200, POWERMAX1650, POWERMAX1250, POWERMAX65, POWERMAX85, POWERMAX45, POWERMAX30, Kjellberg consumables for HiFocus80i, HiFocus100i, HiFocus130i, HiFocus160i, HiFocus280i, HiFocus360i, HiFocus440i and so on. Esab consumables for PT-25, PT-36, PT-37, PT-600, PT-15XL, PT-19XL, PT-31XL and so on.
1. Koike consumables for SUPER 400, SUPER 400 PLU.
2. Komatsu plasma consumables for 30KW, 60KW 3082, 3084, 3086, 6082, 6084. 
 
Hypertherm plasma Cutting machine HPR130, HPR260, plasma consumables. Hypertherm plasma HPR260 plasma cutting accessories, Hypertherm HPR130 plasma torch parts, hyperherm plasma cutter nozzle 220182, plasma cutting nozzle 220188, hyperherm electrode 220181, plasma cutter tips 220187, hyperherm shield 220183, hyperherm cutting shield 220189, hyperherm swirl ring 2200179, Plasma cutter swirl ring 220553. plasma cutter water tube 220340. plasma inner cap 220176, plasma retaining cap 220173, plasma cutter parts 220552.
 

 

 
 
 
Technical Support:
plasma cutting arc fault analysis
 
5. earth wire and workpiece contact
 
Grounding is an essential preparation before cutting. Without special grounding tool, the workpiece surface with insulation and long-term use of aging serious ground wire, etc., will make the earth and the workpiece contact. Solution: use a special grounding tool, and check whether the insulation effects of the ground and the workpiece surface contact, avoid the use of aging grounding wire.
 
6. spark generator can not automatically cut off
 
Plasma cutting machine work, first of all to ignite the plasma arc, by the high frequency oscillator excited gas between the electrode and the inner wall of the nozzle, resulting in high-frequency discharge, the gas ionization and the formation of local small arc, the small arc by compressed air, ejected from the nozzle to ignite plasma arc. This is main task spark generator. Under normal circumstances, the working time of the spark generator is only 0. 5 ~ 1s, can not be automatically cut off the reasons for the general control circuit board components, the discharge electrode gap between the spark generator is not suitable. Solution: should always check the spark generator discharge electrode, so that the surface is smooth, timely adjustment of the discharge electrode gap of the spark generator (0. 8 ~ 1. 2mm), if necessary, replace the control panel.
 
7. other
 
In addition to the above reasons, the cutting speed is too slow, cutting the verticality of the torch and workpiece, and the operator of the plasma cutting ma