Shanghai Zhoubo welding & cutting technology CO.,LTD.
|
Place of Origin: | Zhejiang, China (Mainland) |
Add to My Favorites | |
HiSupplier Escrow |
Hypertherm 220992 Retaining Cap Plasma Torch Consumables For PowerMax105 Handle Cutting
We can offer you all plasma consumables for hyptertherm, Kjellberg, Esab, Koike, Komatsu, Thermadyne, such as: electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.
Machine | HEC NO. | Ref NO. | Description |
PowerMAX 45 PowerMAX 65 PowerMAX 85 PowerMAX 105
|
H71857 | 220857 | Swirl Ring 45/65/85Amp |
H71994 | 220994 | Swirl Ring 45/65/85/105Amp | |
H71947 | 220947 | Swirl Ring FineCut | |
H01842 | 220842 | Electrode 45/65/85Amp | |
H11941 | 220941 | Nozzle 45Amp | |
H11819 | 220819 | Nozzle 65Amp | |
H11816 | 220816 | Nozzle 85Amp | |
H11930 | 220930 | Nozzle FineCut | |
H11797 | 220797 | Nozzle 65A/85A gouging | |
H11990 | 220990 | Nozzle 105Amp | |
H11991 | 220991 | Nozzle 105A gouging | |
H41854 | 220854 | Retaining Cap 45/65/85Amp | |
H41953 | 220953 | Retaining Cap 45/65/85A mechanized, ohmic | |
H41817 | 220817 | Shield 45/65/85Amp mechanized | |
H41818 | 220818 | Shield 45/65/85A drag-cutting | |
H41948 | 220948 | Shield FineCut, mechanized, ohmic | |
H41798 | 220798 | Shieldg 65/85A gouging | |
H41931 | 220931 | Deflector FineCut, handheld | |
H41993 | 220993 | Shield 105Amp mechanized | |
H41798 | 220798 | Shield 105A drag-cutting | |
H91955 | 220955 | Deflector 45/65/85A mechanized,unshielded |
Technical Support:
Maintenance of plasma cutting machine
5. check the gas and cooling gas every day
Check the flow and pressure of the gas and cooling gas flow every day, if the flow is not enough or there is leakage, should stop the line fault immediately.
6. avoid torch collision damage
In order to avoid collision damage to torch should be correctly programming avoid walking overrun system, install anti-collision device can effectively avoid the collision torch damage.
7. The damage reason of the most common torch
(1) the torch collision.
(2) the destructive plasma arc due to the damage of the consumable parts.
(3) dirt caused by the destructive plasma arc.
(4) loose parts caused by destructive plasma arc.
8. matters needing attention
(1) do not grease the cutting torch.
(2) don't over use O - ring lubricant.
(3) in protection to remain on the cutting torch when splash do not spray chemicals.
(4) do not take manual torch when use hammer.