HT4400 / HT4001 Hypertherm Plasma Torch Consumables For Hyperther Plasma Cuttting Machine
 
            We can offer you all plasma consumables for hyptertherm, Kjellberg, Esab, Koike, Komatsu, Thermadyne, such as: electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.
           Each of our products has been tested with a rigorous precision instrument, A large number of piercings tests and service life tests, And made batch trial in our customers. If all results are good, then we will producing them.
        

         We are a professional manufacturer of plasma cutter consumables, Our company is located in the Shanghai City, China ,it was established in 2007,but we had 10 years manufacturing experience in this field, the new factory covers an area of more than 10000 square meters .There are 50-100 workers and 20 research engineers.
     

 
 

 

Technical Support:
 The problem of plasma cutting

5.3 The poor quality of cutting

Is cut not to wear the workpiece, or hang slag, slotted uneven. This is main arc has not been sufficient compression, arc column thicker, the penetration problems caused by, main reason is cutting gas pressure is insufficient or cutting gas pipeline leakage. Combined electromagnetic valve control cutting gas, combination switch and trachea, if the use of imitation of the parameters of the nozzle, wrong, cause the turbulence between the nozzle electrode will also be the case.

5.4 spark generator can't be broken arc

Plasma cutting machine work, first of all to ignite the plasma arc, by the high frequency oscillator excited gas between the electrode and the inner wall of the nozzle, resulting in high-frequency discharge, the gas ionization and the formation of local small arc, the small arc by compressed air and ejected from the nozzle to ignite the plasma arc, which is main task spark generator. Under normal circumstances, the spark generator working time is only 0. 5 ~ 1s, the reason does not automatically break arc is generally offset control circuit board components, discharge electrode gap of the spark generator is not right. Should always check the spark generator discharge electrode, make the surface smooth, timely adjustment of the discharge electrode gap spark generator (0. From 8 to 1. 2mm), it is necessary to change control board.